F8T rear dogbone issue

[ventdependent]

Howdy everyone,

Took my fusion f8t out with the MMM 2200 kv and had a friggen blast. However, on my second drive the right rear dogbone shot out of the car. When I went to put it back in there was TONS of play.

I took it to a hobby shop and they jury rigged some sort of stopper in there to cut the play down.

Anyways, the front wheels are connected via CVD's. Can I order CVD's for the rear twheels? If so, where can I find this part. I've looked but only found CVD's for the center drive.

Any help or tips would be appreciated.

Otherwise this truggy is EVERYTHING I wanted out of a RC. This thing on 6s lipo is just silly.


Vent

[REAPER]

hear you go

http://casterracingusa.com/product.php?productid=63&cat=6&page=3

[ventdependent]

Thanks!

I may be asking for some advice how to put these things in. For now its time to experiment with my tinkering capabilities.

Vent

[simplechamp]

Just remember to put threadlock on the set screws in the CVD joint, and the set screws in the axles.

[adrictan]

I use shrink tube after threadlocking the set screws. The alternative is using shoe goo.