keep throwing rear drive shaft

[smeee]

have the SB10 rtr and took it out to day for the first time and half way through the run the rear drive shaft ended up on the floor (had to do this 3 times)
not great start but had fun when it was running, on closer inspection all apears to be fine. however if you hold the drive shaft and push towards the diff then the drive shaft pops out at the wheel end. almost as if either the shaft is to short or the spring in side has not enough tension. anyone else have had this problem? if so how did you go about fixing it.

[smokinu]

you need to take some Fuel line or small orings and put a slice in each outdrive to keep the Dogbone Cenntered through out the Cycle of the suspension

The Perma Fix is to Get another Set of Front cvds and Mount them in the Rear.

[YDBD]

dump the springs and replace with fuel tube, suprised the spring was still in there...

[Day]

You can also do what I've done.
Adding a few O rings has solved this problem totally.

http://i2.photobucket.com/albums/y28/day172/NewImage.jpg

[smeee]

thanks for the tipsd guys, when i get some time i will try mr Days tip (as im a plumber i have plenty of o rings). will let you know how things go.

[bando711]

you need to take some Fuel line or small orings and put a slice in each outdrive to keep the Dogbone Cenntered through out the Cycle of the suspension

The Perma Fix is to Get another Set of Front cvds and Mount them in the Rear.


The front cvd's will not fit on the rear. Has anyone found a set that fits the rear?

[audriusv]

The front cvd's will not fit on the rear. Has anyone found a set that fits the rear?

Hi,

Caster ones fits afaik ;)

SKOP034 Rear CVD

[YDBD]

caster usa doesn't have those in stock that I can find...

[hakmazter]

the 34s? Yes we do. I sent you a set with your newest order since I thought you ordered them last time when the box received was different than the order list.

I better go check the cart.

[YDBD]

I only see the SKOP032 and SKOP033 center CVA's...