Alignment

[rrmccabe]

I noticed my front suspension was binding when the a-frames were totally dropped.

Once I backed the "pivot balls" out a little on one side the steering smoothed up.

Manuals says to refer to setting sheet (track wide). Is there a setting sheet available?

It appears you adjust these pivot balls to adjust camber.

Also once you put it back together how do you keep the cap holders in place? Cant crank them in tight or it puts too much pressure on the pivot ball.

Thanks

[Mr Fusion]

I had to back out the PB hubs too (making the front end wider) because the front CVDs were binding against the diff/outdrives.

I don't have the measurements... and I don't know what the legal width is or anything. But I'm assuming it was pre-built with the front end too narrow.

Check to see if that's what is binding on yours.

Cap holders?

[BigC123]

274mm on the bottom pivit ball, its going to be about three threads out on the ball then back out the top one to get the right camber that you want.?&^

[vnmsgt]

274mm on the bottom pivit ball, its going to be about three threads out on the ball then back out the top one to get the right camber that you want.?&^

That is what I did to mine and it worked perfectly.

[hakmazter]

ummm. you have it in the owner's manual and you have it in pdf form in the downloads section.....wow, I feel like Cam.

[rrmccabe]

ummm. you have it in the owner's manual and you have it in pdf form in the downloads section.....wow, I feel like Cam.

You must, you are sounding like Cam.

Care to show me where it is in the manual? Either paper copy or PDF?

[hakmazter]

ok, so I didn't see it in the downloads section. manual is at work....must go look at flashdrive.....I'll be back....