3 piece speedy mount thread size.

[rrmccabe]

Anyone know the size of fasteners that hold the top pieces of the speedy mount to the main bottom one?

I knocked one off back of bench and it fell inside wall. I was going to bring it with me to the office today but I forgot. Planning on making a fastener run on the way home.

It can wait but thought someone might know.

[razzor]

its a M4 screw if not mistaken same as the motor mount screws that go underneath the chassis just make sure you get 10mm long ones.

[vti-chris]

I just purchased the Dragon Racing engine mount which fits the Mugen and Caster i suppose. Has anyone tried it out?

[Mr Fusion]

I think I used M3 caphead screws on the top of my 3-pc moun, and M4 on the bottom part.

[vnmsgt]

I just purchased the Dragon Racing engine mount which fits the Mugen and Caster i suppose. Has anyone tried it out?

I have not. I use the Caster ones. They are great and cheaper than others but I do not know how much the dragon racing ones are. Alot of people say dragon racing aluminums very weak. I had a chassis of theres and it seemed fine to me on another truggy I had.

[rrmccabe]

I think I used M3 caphead screws on the top of my 3-pc moun, and M4 on the bottom part.

It takes 3mm and 4mm on the top. 3mm to hold the motor to the mount and 4mm to hold the top mount to bottom mount. Then of course 4mm holding the mount to the chassis from the bottom.

I think Caster should change their mount kit to include (4) 4mm x 10 screws with this kit. Even if it means bumping the price a little.

[razzor]

It takes 3mm and 4mm on the top. 3mm to hold the motor to the mount and 4mm to hold the top mount to bottom mount. Then of course 4mm holding the mount to the chassis from the bottom.

I think Caster should change their mount kit to include (4) 4mm x 10 screws with this kit. Even if it means bumping the price a little.


That is a good suggestion and what i was thinking too.

[vnmsgt]

Yeah I had to go scrounging around for the screws to use mine.